User Tools

Site Tools


errors_window

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
errors_window [2021/08/18 08:46]
mina [Errors window]
errors_window [2022/05/09 16:00] (current)
mina
Line 8: Line 8:
 A maximum of one error per block is reported. This means that if you fix one error, another might appear. Also, there is a total upper limit of 100 errors being reported. A maximum of one error per block is reported. This means that if you fix one error, another might appear. Also, there is a total upper limit of 100 errors being reported.
  
-Note that the error list must be empty for the “Run”-simulation button to be activated.+Errors are caused by missing values, wrong dimensions etc. They indicate big issues inside the model: Note that the error list must be empty for the “Run”-simulation button to be enabled. Until errors are resolved, it is not possible to run the simulation
  
 This window displays warnings as well. Warnings are usually caused by mis-matched or missing units etc. Warnings do not stop the project from running, but might be cause of some errors in the results. Therefore, it is not necessary to resolve all warnings, however they should be inspected in case they indicate modeling errors.  This window displays warnings as well. Warnings are usually caused by mis-matched or missing units etc. Warnings do not stop the project from running, but might be cause of some errors in the results. Therefore, it is not necessary to resolve all warnings, however they should be inspected in case they indicate modeling errors. 
errors_window.txt · Last modified: 2022/05/09 16:00 by mina