In this lesson we will set start and end time, select simulation outputs and run a simulation.

Simulation settings

1. Click the button in the toolbar or select Simulation | Simulation Settings from the Menu bar.
2. Make sure that the General tab is selected. Set the Time unit to Days and the End time to 100.
3. Select the Outputs tab
4. Select all the blocks of the model, including the transfers.
5. Click Ok to close the window.

Running a simulation

1. Click the Simulation button on the toolbar.
2. Click the button on the toolbar to start the simulation.
3. When the simulation has finished, the Results window should list the blocks that you selected to be simulation outputs above.

Next

• Inspecting results (7/7)

Previous

• Assigning material dependent values (5/7)

References

• Back to Tutorials
• Home